Questions Before You Book a Session

Our shop sits on SW Archer Road in Gainesville, and we regularly see clients from Alachua, High Springs, Newberry, Micanopy, Hawthorne, Waldo, Archer as well.

It's a short written log of the turf firmness, grass type, wind, and divot behavior we record while walking three real lies before your fitting. It becomes the reference point for every spec change that follows.

No. Turf behavior matters at every skill level. Higher-handicap golfers often see the largest gains, since a mismatched bounce or sole width on firm turf tends to punish an inconsistent strike the most.

Single-club fittings run 45–60 minutes. Iron set fittings run 60–90 minutes. A full bag course rebuild covering driver through putter typically takes 2.5–3 hours.

No. You'll receive a full written course card with recommendations regardless of whether you order. If you do build with us afterward, your session fee is credited toward the total.

A simulator tells you what happened to the ball on a flat, forgiving mat. Walking real turf first tells you how the club will actually behave once it meets the ground you play on, so recommendations hold up past the bay.

Bring the clubs relevant to your fitting, the shoes you normally wear on the course, and a rough sense of your typical scores if you know them.

Yes. Our wall carries left-handed heads across every major category, and the course-card process works identically for right- and left-handed swings.

Absolutely. Plenty of clients come in just to confirm their current build actually matches the turf they play, or to check lie angle and bounce on clubs they already own.

Most builds are finished in-house within a week, since we stock components on-site rather than routing orders through an outside factory queue.